- A choice of glitters.
- Glue
- Screw Punch
- Bunny template (http://vectorclipartsales.com/image.php?src=163) enlarge to the size that you need.
- Plastic spoons.
- Cardstock
Use your Screw Punch to punch holes less than one half of an inch away from each other all around the bunny. The bigger tip works best.
This image shows what the entire emage should look like when punched all of the way around the bunny.
Be sure that you have your glitter handy. It works best if you have it in a little containers like shown above. You can access it easier, and it looks better.
Take out your cardstock that you will be using to make your card. Fold it in half using your bone folder. Depending on the size that you make your bunny in the beginning, will now determine which way your card will be. My card will be side to side because my bunny is to long to fit the other way.
Place your bunny on top of the card. Make sure that all of the holes are covered by the color of the cardstock that you chose for your card.
Put some glue out onto a square of cardstock like this. You can use the back of a spoon, or a paint bursh to spred the glue. 
Spred the glue. Make sure that during the process of spreding the glue you dont move the bunny from the place it was when you started. You will not want to get glue all over your work surface as well as ruin the outcome of your card. 
Remove the white punched bunnyy from the card. You should get a perfect impression of the bunny. If you have gaps, you can use a glue pen to fill in.
Spred the glue. Make sure that during the process of spreding the glue you dont move the bunny from the place it was when you started. You will not want to get glue all over your work surface as well as ruin the outcome of your card. Remove the white punched bunnyy from the card. You should get a perfect impression of the bunny. If you have gaps, you can use a glue pen to fill in.
Glitter your entire glued surface on the frount of the card.
Have a white piece of regular printer paper ready to dump out all of the excess glitter onto.
After allowing the glue to dry for about 1 min. then you can dump all of the excess glitter onto the white paper.
Do not throw away any of the excess gilitter. It is still good to be used again.
Use a folded piece of white paper or cardstock to cover the inside of your card. You can choose to stick it down with glue or with double sided tape.
When you are done you should have a perfect impression of a bunny. Happy Easter.This idea can be used to make not only cards for easter. You can make your own template of any thing, then punch and glitter.
Have a good day.
No comments:
Post a Comment